ISO 9001 CertifiedPPAP CapableOEM / ODM to Drawing

Stainless Steel Screens and Baskets for Water Treatment

Water and wastewater treatment moves huge volumes of liquid that carry everything from leaves and grit to fine suspended solids. Stainless steel screens and baskets do the mechanical work of removing that material — and because they run wet, continuously, and often in corrosive water, stainless is the natural material choice. A single plant may use a dozen different screen forms, from a coarse bar-and-mesh intake screen to a fine sintered element polishing water before reuse. Getting each one right protects the equipment downstream and keeps the whole train running.

Where stainless filtration is used

  • Intake screening: coarse screens and strainer baskets remove leaves, debris and grit before water reaches pumps and treatment stages.
  • Pump and equipment protection: basket strainers guard pumps, valves, heat exchangers and flow meters from particulate that would erode or jam them.
  • Process and fine filtration: finer mesh elements and filter cylinders polish the water at later stages, ahead of membranes, UV or disinfection.
  • Wastewater and reuse: durable screens handle abrasive, variable-load streams and repeated backwash cycles.
  • Chemical dosing and sludge lines: small in-line strainers keep nozzles and dosing pumps from clogging.

Why stainless steel

Water treatment is wet, continuous and often chemically aggressive — chlorine, chloramine, coastal salt or process chemicals attack ordinary materials. Stainless resists that corrosion, is fully cleanable and reusable, and holds its shape under flow, pressure and backwash cycles that would collapse a plastic screen. The grade decision comes down to water chemistry:

Grade Best for Watch-outs
304 / 304L General fresh water, municipal supply, low-chloride process water Pits in high chloride or coastal service
316L Coastal, brackish, chlorinated or high-chloride water; the molybdenum resists pitting Higher cost, still limited above ~1,000 ppm chloride
Duplex (2205) Seawater intake, desalination pre-treatment, very high chloride Specify only where 316L is marginal

For most plants the choice is 304 versus 316L; if you are borderline, our guide to 304 vs. 316L stainless steel walks through the chloride limits. After fabrication, screens should be passivated to ASTM A967 to restore the chromium-oxide layer at cut edges and welds, where corrosion otherwise starts.

Construction that survives backwash

Screens fail at their joints, not in the middle of the cloth, so construction matters as much as material. Perforated support cylinders carry the pressure load while the fine mesh does the filtration; the two are seam- or spot-welded, and end caps are TIG or seam welded to be leak-tight so nothing bypasses the media. Reinforced rims and handles let operators pull and clean a basket without deforming it. Where a screen must survive thousands of backwash reversals, the mesh is sintered or Dutch-woven for rigidity rather than left as a loose plain-weave cloth.

How to specify

  • Stage and duty: intake screening, pump protection or fine filtration — each needs a different opening size and construction.
  • Opening size: from coarse perforated screens (several millimetres) down to fine woven mesh (tens of microns), matched to the solids you must remove. If you only have a micron target, see mesh count vs. micron rating.
  • Grade and finish: 304 for general fresh water; 316L for coastal, chlorinated or brackish water; passivated after welding.
  • Flow and pressure drop: give us the design flow and allowable clean pressure drop so we can size the open area — undersized screens blind quickly and force constant cleaning.
  • Form and fit: baskets, cylinders or flat screens built to your housing, with the correct flange, gasket seat and orientation. See our Water Treatment Filtration page and baskets & strainers range.

Frequently Asked Questions

Which grade for coastal or chlorinated water?

316L, for its molybdenum-boosted resistance to chloride pitting; 304 is fine for general fresh water. For seawater or desalination pre-treatment, ask about duplex.

Can basket strainers be cleaned in place?

Many are designed for easy removal and cleaning or backwash — tell us the duty and we’ll build in reinforced rims and handles for serviceability.

Coarse or fine — which do I need?

It depends on the stage: coarse for intake and pump protection, fine for process polishing. We can supply both, and multi-stage screens that do both in one housing.

Do screens need passivation?

Yes — after welding, passivation to ASTM A967 restores corrosion resistance at the cut edges and welds where pitting would otherwise begin.

Have a water-treatment screen or basket to source? Send your housing, flow and water chemistry and we’ll build a corrosion-resistant screen to spec. Request a quote →

Leave a Comment

Your email address will not be published. Required fields are marked *

×
WhatsAppEmailGet a Quote
Scroll to Top